Q: What kind of blade locking mechanism is used on the mechanicals?

A: On our new patent pending Pop n Lock design, the locking tabs on the blades lock against the ferrule and act as a retention device inside the ferrule.

Q: How big are the holes with the mechanicals? (my favorite question)

A: 1.75” mech is getting 2-2.25” entries consistently and occasionally larger than that. The 187 (actually a 2” cut) is getting 2.5-3” consistently.

Q: Where are your broadheads made?

A: Over 1/2 of production comes from USA and other portion sourced globally. With over 1/2 we could claim “made in USA” like other manufacturers do, but we are honest and do not believe in that practice.

Q: How well does the tip hold up?

A: The tip holds up extremely well since it is .060” thick and 1/2” wide. It also acts as a bleeder blade in all of the designs.